![]() Reconnect the water supply to the toilet and turn the water back on. Carefully put the tank back into place and reinstall the tank-to-bowl hardware. Install the new flush valve, tighten the flush valve nut, and replace the tank-to-bowl gasket. Consider enlisting a partner to help make this process easier. Carefully lift the tank off of the toilet so that you can access the toilet-to-bowl gasket and loosen the flush valve nut. Take out the old flush valve by disconnecting the flapper and removing the tank-to-bowl bolts. Use a cloth or towel to dry up any remaining water before disconnecting the water supply to the tank with a set of channel locks. Turn off the water to the toilet using the isolation valve located on the water inlet line, then drain the toilet tank by flushing the toilet. If the water from the tank continues to seep into the toilet bowl, or you find that the overflow tube is too short, then the entire flush valve will need to be replaced. The water continues to flow until the tank is empty, then the flapper returns to its previous place, sealing the tank.When the additional water enters the toilet bowl the water level increases, allowing it to flow through the trap and into the main drain.The water rushes into the toilet bowl through evenly spaced rim holes and may have a secondary entry point known as a siphon jet to help increase flushing power.The flapper opens and releases the water inside the tank. Pressing down on the handle or button pulls on a chain that is attached to the flush valve flapper. ![]()
0 Comments
Leave a Reply. |
AuthorWrite something about yourself. No need to be fancy, just an overview. ArchivesCategories |